If Automatic Loudness Control (ALC) is also required, that too is a licensed feature
and the same number of ALC licenses as the encode licenses will be needed to
enable the feature across the ABR profile set.
3.7.7 How to Use ABR Templates
The AVP 4000 provides a default set of 10 ABR profiles that will be created when
the user creates an ABR service. For specific customers, the default set may be
changed by uploading a template which has been created for their specific use-
case. The template works in cooperation with underlying software and is not a
method of obtaining generic changes to the profile set. Please contact Ericsson
Television Product Management if you need such a template or change.
To use a template
1. Ensure the chassis is licensed and configured to support ABR.
2. Before creating an ABR service, go to Device Configuration > Advanced
Setup > ABR Template Management to select and upload the template file
supplied.
3. Create the ABR service as documented in section 3.7.6.3 How to Set Up Your
Services.
Figure 3.12 Creating an ABR Service
3.7.8 How to Set up Encode Using Two Broadcast Cards from a Single HD-
SDI Source
The AVP 4000 provides the capability of encoding two outgoing services of HD, one
of which may be used in a statistical multiplex group, and the other CBR, or both
CBR. This is achieved using two EI9001 cards but only sourced from a single HD-
SDI feed.
To Next Page
Loading...
