8. To transcode a service in the output Transport Stream, simply drag-and-drop the
selected input service to the Transport Stream output.
Figure 3.23 Service Configuration Web Page – Adding a Service
Note: Only Services can be dragged-and-dropped for transcode operation,
Transport Streams and video/audio/data components cannot be.
9. Select Transcode through a card on this device.
Figure 3.24 Service Configuration Web Page – Remux or Transcode
10. The Transcode Configuration wizard will prompt you the card to use for
transcode operation, the format of the incoming video, and to select which
components you want to transcode or pass-thru. By default, the first available
transcoder card is being used.
To Next Page
Loading...
