Ericsson AXX 9100 CONNECT - Change Passwords

AXX 9100 CONNECT R1.2 Quick Reference Guide
3/1531-ZAP 701 14/1 Uen A 2006-10-16
38
2.1.3.2 Assign an IP address (System Mode - IP)
If system mode is IP the command for IP configuration is:
1. AXXCLI>IP-Configuration IP-ADDRESS=193.69.136.104
SUBNET-MASK=255.255.255.0
2.1.3.3 System Mode - IP Unnumbered
1. AXXCLI>Management-modes\sys sys=ipun
Change management configuration, are you sure?
(y/n)?
2. Enter “y”
3. Afterwards reboot NE.
2.1.3.4 Assign an IP-address(IP Unnumbered)
If system mode is IP unnumbered the command for IP configuration
is:
1. AXXCLI>Device\Management-Configuration\IP-Configuration IP-
ADDRESS=193.69.136.104 SUBNET-MASK=255.255.255.0
For most commands, if no parameters are supplied then all the
current parameter values are displayed.
AXXCLI>IP-Configuration
IP-ADDRESS: 10.0.0.1
SUBNET-MASK: 255.255.255.0
DEFAULT-GATEWAY: 10.0.0.254 (optional)
2.1.4 Change Passwords
AXXCLI>ch ?
Usage:
Change-Passwords
[AXXCLI-PASSWORD=<string[6:12]>]
[TELNET-PASSWORD=<string[6:12]>]