Error! Unknown switch argument.
4 (8)
Datum - Date Rev Nr - No.
Error!
Error!
Error! Unknown
Error! Unknown switch argument.
Back-to-back repeater
RX
F1
TX
F2
DUPLEXER
TX = F1
RX = F2
TX = F3
RX = F4
RX
F3
TX
F4
DUPLEXER
Fig 2. Back-to-back repeater
This is basically two carrier controlled repeaters connected together with a
special "back-to-back" cable. The back-to-back repeater makes it possible to
carry out full duplex conversation. It can be used for different purposes:
converting from one frequency band to another, to extend repeater coverage
to remote areas or just as a full duplex repeater between mobile duplex
stations. Note that this configuration involves no tone equipment and is only
controlled by carrier wave.
To Next Page
Loading...
