Ericsson Base Station F800 - Electrical Connections; How to Set up Your Prom Programmer Equipment; What Can be Programmed

Fel! Okänt växelargument.
4 (5)
Datum - Date
Rev
Nr - No.
Fel! Okänt
Fel!
Fel! Okänt
Electrical connections
IBM Compatible PC
PROM Programmer
Equipment
Serial cable
RS232 Port
RS232 Port
EEPROM
Xicor
28C64
Connect your PROM programmer equipment to one of the serial, RS232,
ports on the PC. Usually it is COM1 or COM2. See your PROM programmer
equipment manual for how to make this connection.
How to set up your PROM programmer equipment
Set the prom programmer equipment to the preferred speed and file format.
Usually it is 9600 baud, no parity, 1 stop bit. The recommended file format is
"Motorola S-record". Set the programmer to receive a file from the PC. See
the user manual for your prom programmer equipment on how to do this
setting.
What can be programmed?
The F800 can be programmed with some basic radio data:
• Frequency band (depending on hardware)
• Traffic mode (usually simplex or duplex, depending on hardware)
• TX frequency for each channel
• RX frequency for each channel
• RF output power for each channel, high or low (usually 20 or 2 Watt)
Fel! Okänt växelargument.