EasyManua.ls Logo

Ericsson CME 20 R6.1 - Page 223

Ericsson CME 20 R6.1
307 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Channel Distribution Function
35.3.2 Scanning of Terrestrial Channels
The function is initiated:
When the CMRU is in Local mode and the Remote button is
pressed
When the CMRU is in Remote mode and (re-)started
When CF has lost its layer 2 connection to BSC
When the CF link is disconnected (reception of DISC command
frame)
RBS searches all terrestrial signalling channels, plus a number of
unoccupied terrestrial channels, for data link establishment attempts
directed towards CF.
Searching for the establishment attempt is performed by the CF in
intervals of one second. The searching can be performed in two ways.
Initially, when no valid CDF configuration exists, one set of unoccupied
terrestrial channels is searched in each interval. If no establishment
attempt is found during an interval, the search is continued on the next
set of unoccupied terrestrial channels. The search is repeated until an
establishment attempt is found.
If the scanning function is initiated when a valid CDF configuration
exists, the search in each interval is performed on all the configured
terrestrial signalling channels plus one set of unoccupied terrestrial
channels. Thus all unoccupied terrestrial channels are searched in a
cyclic way and all configured terrestrial signalling channels are searched
continuously.
After a search-time of 5 minutes, the entire configuration of the channel
distribution function is erased (all set up connections are lost and have
to be reconfigured). The search continues but now all terrestrial
channels are defined as unoccupied.
The function is terminated when the layer 2 link to CF is established or
when CMRU enters Local mode.
35.3.3 Sharing Terrestrial Signalling Channel
The function is initiated when the channel distribution function becomes
configured in such a way that the same terrestrial signalling channel is
used for signalling to both MO CF and to one or more TRXs. This is
the normal condition that occurs at configuration of the first TRX.
It is also initiated when RBS has, during scanning of terrestrial
channels, found a link establishment to CF on a terrestrial signalling
channel already used for signalling to one or more TRXs.
The function shares signalling to/from MO CF and signalling to/from
one or more TRXs on a shared terrestrial signalling channel.
222 (306)
EN/LZT 123 2697 R5A
1998-08-13
© Ericsson Radio Systems AB
All Rights Reserved

Table of Contents

Related product manuals