Ericsson Dialog 4225 Vision - Programming of Ring Signal Tone Character

Settings
Dialog 4223 Professional/Dialog 4225 Vision102
Programming of ring signal tone character
There are 10 different programmable ring signal tone characters on
your phone, each corresponding to a digit between 0 and 9.
Note: If you use melodies to signal incoming calls, this will
replace the tone character. See section “Melody Ringing”
on page 107.
Dialog 4223 Professional:
Program Press (see display).
If
Program is not shown, press more... until appearing.
Select Press (see display).
The current tone character is displayed.
( 0– 9) Press the corresponding digit.
The phone rings with the chosen character.
Exit Press to finish programming (see display).
Dialog 4225 Vision:
Å Select Program in the top menu (see display).
Select Press to select Programming of keys (see display).
The current tone character is displayed.
( 0– 9) Press the corresponding digit.
The phone rings with the chosen character.
Exit Press to finish programming (see display).