Call Forwarding
BusinessPhone – Ericsson Dialog 4422 IP Office36
Program and activate External Diversion
Divert your calls to a new external diversion address:
Note: To use the external diversion function, your extension
has to be authorized by the system administrator.
*22* Dial.
0z Dial the digit(s) for external line access and enter the new
external diversion address.
A maximum of 24 digits.
Note: Which digit to press for external line access depends
on the configuration of the system.
# Press to activate the diversion.
Verification tone.
í Press to finish the procedure.
Note: Before you leave, call your extension to check if the
External Diversion has been set up correctly. Individual
External Diversion can also be used via the DISA function,
see section “Other Useful Features” on page 55.
Cancel External Diversion
#22# Dial.
Verification tone.
í Press to finish the procedure.
New incoming calls will be signalled on your phone again.
Note: The programmed diversion address is not removed
from memory, the diversion is just inactive.
Re-activate External Diversion
Divert your calls to an external diversion address.
*22*# Dial to activate the programmed External Diversion.
Verification tone. You can make outgoing calls as usual. A special
dial tone reminds you that call forwarding is active.
í Press to finish the procedure.
To Next Page
Loading...
