IndexIndex
spanning_tree
statistics
vlan
Example
The following example will reset the statistics counters on all ports:
efn# reset statistics ethernet_port *
13.8 Configuration Commands
The commands listed in Table 12 on page 106 are used when configuring the
system. The set command is used together with some of the commands.
Table 12 Configuration commands
Command Description Page
add/remove
connection
Configure or remove specific connection data. 107
add/remove
host_accesslist
Define the IP hosts that are allowed to access the
management interfaces.
108
Remove
network_processor
Remove entries in the MAC or bridging table, based on
MAC address, port and IP-address.
109
add/remove rapid
spanning_tree
Add or remove the Rapid Spanning Tree (RSTP) function. 110
add/remove
spanning_tree
Add or remove the Spanning Tree (STP) function. 112
connect vlan
Connect a port to a switching domain, and specify QoS
parameters for the connection.
114
disconnect vlan
Disconnect a port from a switching domain. 117
bandwidth_limitation
Specify the bandwidth limitation in connections. 118
Connection
Configure specific attributes associated with a connection
between a VLAN and an Ethernet port.
120
connection_flow
Configure the QoS parameters for a flow. 121
Cpu
Set basic IP parameters. 124
To Next Page
Loading...