IndexIndex
ethernet_port <port> - Insert the number of the Ethernet port.
Range 1 to 26.
static_ip_addresses <IP_address> - The IP addresses that are
set manually, to be used for IP validation during forced forwarding. These
addresses are defined by the operator, using the add/remove
connection commands.
valid_multicast_groups <IP_address> - Multicast addresses for
multicast groups which users behind this connection are allowed to join, in
other words, a White List. If no address is defined, all addresses are
allowed.
static_multicast_groups <IPv4-address> – add or remove a
multicast address permanently for a connection.
Default Setting
None.
Example:
efn# add connection vlan 100 ethernet_port 4
static_ip_addresses 134.138.159.71
13.8.2 add/remove host_accesslist
Use this command to define the IP hosts that are allowed to access the
management interfaces. Use the command reset host_accesslist to
reset to default values.
Syntax
add host_accesslist permit ip_address <IP-address>
net_mask <netmask>
remove host_accesslist permit ip_address <IP-address>
net_mask <netmask>
Arguments:
ip_address <IP-address> - The IP address of a host that is allowed
to access the management interfaces.
To Next Page
Loading...