Glossary
ethernet_port Warning message
------------- -------------------------------------------------------------
10 "Cannot change scheduling for a Ethernet Port having active
connections. For scheduling to be applied in Hardware either
disconnect the connections and set the scheduling or save the
configuration and restore it."
Default Settings
auto_negotiation: yes
crossover: auto
duplex: full
enabled: yes
link_trap_enabled: yes
scheduling: sp
speed: 100
Example:
efn# set ethernet_port 2 enabled yes link_trap_enabled yes
scheduling sfq
13.8.15 set filter_profile
Use this command to define filters and actions that optionally may be added to
the switching rule collection in the network processor. Use the command
reset filter_profile to reset to default values.
Syntax
set filter_profile <filter-profile>
global_filter_<global-filter>
{change_da <mac-address> |drop|forward|send_to
{ethernet_port <port>|host_port <host-port>
|vlan <vlan>}}
Arguments:
<filter-profile> - Filter profile number. Range 1 to 8.
<global-filter> change_da <mac-address>
/drop/forward/send_to ethernet_port <port>/host_port
<host-port>/vlan <vlan> – Action to be taken when the packet
matches with the global filter. 8 global filters can be defined (or none) and
inserted.
The actions specified above have the following meanings:
To Next Page
Loading...