IndexIndex
vmac_address_node_id <0-8191> - Set the VMAC address Node
ID to a single integer value, from 0 to 8191. The value is inserted into the
first 13 bits of the Port ID field in the VMAC frame.
[Transfer_protocol <ftp|ftps|sftp|tftp>] - configures the
SFTP (Secured FTP) and FTPS( Secured using SSL) Protocols which are
used for the Software upload/download , upload/download configuration
and automatic configuration download.
[username <undefined>] – configures the authenticated user with
the name (string) that is going to do the Software upload/download ,
upload/download configuration an ainly automatic configuration downloa
nd backup using SFTP/FTPS protocols.
[password <undefined>] - configures the password for the user,
that is going to do the Software upload/download , upload/download
configuration and mainly used for automatic configuration download and
backup using SFTP/FTPS protocols which is encrypted by EFN324.
telnet_service <yes|no> - Enable or disable the Telnet services
on EFN324. If this is set to no, then the EFN will not connected
successfully through telnet session by the user.
Note: Reset node_control sets all the node control parameters to default
values.
Default Settings
eda_vmac_format is no.
flexible_block_id is 0 (zero).
network_element_id is 0 (zero).
relay_agent_eda_ip is 0.0.0.0.
relay_agent_eda_sid is 0 (zero).
vmac_address_node_id is 0 (zero).
transfer_protocol is tftp (default)
username <undefined>.(no default value)
password <undefined>. (no default value)
telnet_service is yes
Command Usage
The command is used to set global parameters.
To Next Page
Loading...