Glossary
[ntp_client {disabled|broadcast|multicast|unicast <IP-
address>}]
Arguments:
<date> – Year – month – day, for example, 2010-09-23.
<time> - hour:min:sec. For example, 03:53:39.
<version> - NTP version.
disabled/broadcast/multicast/unicast <IP-address> - The
IP address of the NTP server.
Default Setting
ntp_client: disabled
Command Usage
The command is used to set parameters for using the Network Time Protocol.
Thereby information about date and time (hours, minutes, seconds) is
available.
Example:
efn# set real_time_clock time 12:10:01 date 2005-11-02
ntp_version 4 ntp_client multicast
13.8.20 set snmp
Use this command to configure SNMP. Use the command reset snmp to
reset to default values and unset snmp to reset to undefined values.
Syntax
set snmp [read_community <read-com>]
[sys_contact <string>]
[sys_location <sys-loc>]
[sys_name <sys-name>]
[trap_community <trap-com>]
[trap_receiver1 <IP-address>]
[trap_receiver2 <IP-address>]
[trap_receiver3 <IP-address>]
[write_community <write-com>]
To Next Page
Loading...