IndexIndex
Default Setting
load_timer: 20
Command Usage
This is the time that the EFN CLI process will wait for a response from the
upgrade process after the upload is initiated. If no response has been received
after the specified time, the EFN will restart.
Example:
efn# set software load_timer 10
13.8.22 set spanning_tree
Use this command to define the Spanning Tree (STP) function. The command
is activated using the add spanning_tree command, see section 13.8.5 on
page 112. Use the command reset spanning_tree to reset to default
values and unset spanning_tree to reset to undefined values.
Syntax
set spanning_tree <tree> [forward_delay <delay>]
[hello_time <time>][ max_age <max-age>]
[priority <priority>]
Arguments:
<tree> – 10 different STP configurations can be defined.
<delay> - Delay for forwarding state changes on STP. Range 4 to 30.
<time> - Configure the spanning tree bridge hello time. Range 1 to 10
seconds.
<max-age> - The maximum time a device can wait without receiving a
configuration message before attempting to reconfigure. Range 6 to 40
seconds.
<priority> - Priority of the bridge. Range 0 to 65535.
To Next Page
Loading...