IndexIndex
[description <string>]
[gateway {auto| ip_address <IP-address>| mac_address
<mac-address>}]
[ip_address {<IP-address>|auto]
[mac_address_learning {no|yes}] [max_dynamic_ip_addresses
<max-dyn-ip>] [max_virtual_mac_addresses <max-vir-mac>]
[multicast {igmp_proxy|igmp_snooping|igmpv3_snooping|
no|yes}]
[proxy_ip_address <IP-address>]
[igmp_immediate_leave {no|yes}]
[igmp_query_interval <interval>]
[igmp_query_response_interval <interval>]
[option_82 {no|circuit_id_eda|circuit_id_tr101|
remote_id_eda|remote_id_tr101|configurable|
vlan_port_mac|vlan_port_sysname}]
[real_mac_dhcp_option <0, 128..254>]
[switching_rule {broadcast|ip_validation|normal|pppoe|
virtual_mac}]
[transit_link {ethernet_port <port>|none}]
[uplink {ethernet_port <port>|none}]
Arguments:
vlan <vlan> – Set the number of the Switching Domain. Range 1 to
200.
allow_anonymous_multicast_subscriber {no|yes} – When
the switching_rule is configured to ip_validation or virtual_mac and
multicast is configured to yes, igmp_snooping or igmp_proxy, then this
setting determines whether EFN324 will validate source IP address in
multicast packets.
The default value is ‘no’ which implies that the EFN324 will validate the
source address. Configure allow_anonymous_multicast_subscriber to 'yes'
only when a client needs to send multicast traffic and it uses an IP
address unknown by the EFN as source address.
arp_and_dhcp_tag <tag> - The inner tag used for upstream ARP
and DHCP messages (on downstream VLAN from gateway). Range 1 to
4095. This defines a parallel VLAN.
arp_and_dhcp_second_tag <tag> - The outer tag used for
upstream ARP and DHCP messages (on downstream VLAN from
gateway). Range 1 to 4095. This defines a parallel VLAN.
check_gateway_source_address {no|yes} – Set this parameter
to ‘no’ to avoid discarding frames with a destination address that is not
equal to the MAC address of the gateway. Using this option is not
recommended and it may be deprecated later.
To Next Page
Loading...