EasyManua.ls Logo

Ericsson MINI-LINK TN R4 ETSI - Page 121

Ericsson MINI-LINK TN R4 ETSI
149 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Management
5.7.2.3 Structured/Unstructured E1
MINI-LINK TN R4 can use up to two of its connected E1s for transport of IP
DCN. The following options are available:
Dedicated E1 for DCN
A structured or unstructured E1 can be dedicated for DCN. For the
structured E1, nx64 kbit/s timeslots can be configured for DCN transport.
The remaining timeslots are unused, that is cannot be used to transport
traffic. For the unstructured E1, the entire 2 Mbit/s is used for DCN
transport.
E1 with traffic pass-through
In a structured E1 used for traffic, nx64 kbit/s timeslots can be used for
DCN transport. The DCN is inserted into the nx64 kbit/s timeslots internally
in the NE. The timeslots used for traffic is cross-connected in normal
manner through the NE.
5.7.2.4 nx64 kbit/s
nx64 kbit/s timeslots can be used for IP DCN as described in Section 5.7.2.3
on page 117.
5.7.2.5 2xE0
A PPP/E0 connection can be established to an external device from the SMU2.
5.7.2.6 DCC Radio Terminal
Each Radio Terminal provides a DCC of nx64 Kbits, where 2n9 depending
on traffic capacity and modulation, transported in the radio frame overhead.
5.7.2.7 10/100BASE-T
Each NE has a 10/100BASE-T Ethernet interface for connection to a site LAN.
This interface offers a high speed DCN connection.
The interface is also used at sites holding MINI-LINK HC and MINI-LINK E
with SAU IP(EX).
5.7.2.8 USB
The USB interface is used for a MINI-LINK Craft connection using a local IP
address.
117
12/221 02-CSH 109 32/1-V1 Uen A 2008-03-14

Related product manuals