Radio Terminals
8454
Figure 68 Separate installation in a 1+0 configuration
4.4.3 Mounting Kits
This section describes the mounting kits used for the 0.2 m, 0.3 m and 0.6 m
antennas. A mounting kit consists of two rigid, extruded aluminum brackets
connected with two stainless steel screws along the azimuth axis. The brackets
are anodized and have threaded and unthreaded holes to provide adjustment
of the antenna in azimuth and elevation.
The support can be clamped to poles with a diameter of 50–120 mm or
on L-profiles 40x40x5–80x80x8 mm with two anodized aluminum clamps.
All screws and nuts for connection and adjustment are in stainless steel.
NORD-LOCK washers are used to secure the screws.
6717
Figure 69 Mounting kit for the 0.2 m compact antenna
The 0.2 m compact antenna mounting kit can be adjusted by ±13
in elevation
and by ±90
in azimuth.
89
12/221 02-CSH 109 32/1-V1 Uen A 2008-03-14
To Next Page
Loading...
