Mechanical Working Instruction
3/000 21-1/FEA 209 544/21 D 2(20)
1 Disassembly
1.1 Process tools
Torque screwdriver, torx no.6 pre-set to 33 Ncm., front opening tool, side-opening tool
1.2 Instructions
# Figure Instruction Note
1 Remove the battery. Keep all contact-
surfaces/display clean of
skin oil. Use gloves!
2 Remove the antenna by
waging laterally and pulling it
out from the phone
Do not break, the antenna
holder/connector may be
damaged.
3 Slide in a top tool under the
front. Make sure that it’s
pushed in to the stop on the
tool
4 Push in the other top tool right
beside of the antenna house.
Push until a snap is heard.
Remove the tool
Don’t bend with the tool
just push.
To Next Page
Loading...
