Installation Instruction
6. Place battery 2, that is, the battery with the temperature sensor holder,
next to battery 1.
7. Attach the temperature sensor to the holder on battery 2. See figure below.
8. Connect the other end of the temperature sensor cable to the BFU. See
figure below.
Figure 33 Battery Temperature Sensor Connections
9. Put battery 3 into the next position.
10. Put battery 4 into the last position on the shelf.
3.6.2 Connecting the Batteries
This section describes how to connect inter-block connectors, gas-evaporating
tubes, and cables to the batteries.
1. Note: If the tools used are not insulated, then do not let them touch any
metal parts of the cabinet.
Attach the inter-block connectors between the batteries as shown in the
figure below. Tighten the bolts to a torque of 8 Nm, using a torque wrench
and a 13 mm socket.
30
1/1531-COH 109 2073 Uen H 2006-11-06
To Next Page
Loading...
