Procedure
Figure 34 Inter-Block Connections
2. Remove the screw from the mounting hole for a gas-evaporating tube. The
hole is positioned in the cabinet floor as shown in the figure below.
3. Screw the angled nipple into the hole.
4. Attach the end cap on the leftmost battery (battery 1) as shown in the
figure below.
5. Attach the gas-evaporating tubes between the batteries as shown in below.
6. Attach the gas-evaporating tube between the nipple and the rightmost
battery (battery 4) as shown in the figure below.
31
1/1531-COH 109 2073 Uen H 2006-11-06
All manuals and user guides at all-guides.com
To Next Page
Loading...
