Procedure
2. Remove the ACCU front cover, by unscrewing the three screws, using a T8
Torx screwdriver, and hook the plate off as shown in the figure below.
Figure 11 ACCU Front Cover Removal
3. Route the power cable through the cable inlet as shown in the figure below.
4. Strip the cable sheath of the power cable to an appropriate length, using
cable shield cutters.
5. Strip about 10 mm of the power cable conductors, using a wire stripper.
6. Connect the cable conductors to the terminal blocks. Tighten the screws to
a torque of 5 Nm, using a torque wrench and a 5.5 mm flat bit.
7. Tighten the cable gland by hand.
17
1/1531-COH 109 2073 Uen H 2006-11-06
To Next Page
Loading...
