Ericsson RX8000 Series - Setting up SNMP Remote Control; Snmp

Remote Control
Figure 4.1 Typical Web Browser Status Page
For more information on the Web Browser interface and a description of the
available web pages, see Chapter 5, Web Browser Control.
4.5 SNMP
Simple Network Management Protocol (SNMP) is available as a standard feature on
all of the RX8000 Series Receivers.
SNMP is a network protocol used to monitor network-attached devices for conditions
that warrant administrative attention. SNMP consists of a set of standards for
network management, including an application layer protocol, a database schema,
and a set of data objects.
The RX8000 Series Receivers support SNMP Versions 1, 2C and 3.
For more detailed information on SNMP remote control, contact Ericsson.
4.5.1 Setting Up SNMP Remote Control
SNMP remote control is enabled by default.
To set up SNMP remote control:
1. Ensure the Web Browser Interface is connected and working.
2. From the browser SNMP tab, select the version of SNMP required (V2C or V3).
EN/LZT 790 0005 R1A
4-6