Ericsson RX8000 Series - Page 136

Chapter 5
Figure 5.20 Input > IP Input Web Page
The following user-editable fields are displayed on this web page:
User-editable fields in the IP Interface Section:
• IP Address 1/2 – allows the user to input the relevant IP address.
• Subnet Mask 1/2 – allows the user to input the relevant Subnet Mask address.
• Default Gateway 1/2 – allows the user to input the relevant Default Gateway
address.
• VLAN (Virtual Local Area Network) Tag 1/2 - allows the user to input the
relevant VLAN Tag Value.
• VLAN Enable 1/2 - allows the user to enable/disable the VLAN.
• ICMP (Internet Control Message Protocol) Enable 1/2 – allows the user to
enable/disable network 1/2 to ping the input (and Port 1/2).
• SNMP Enable – allows the user to enable/disable the SNMP facility via the input
port.
• IP params to XML output – allows the user to enable/disable the sending of the
IP parameters out as XML from the input port.
User-editable fields in the Card Config Settings section:
• ARP Enable 1/2 – allows the user to enable/disable the ARP on Network 1/2.
• Ethernet Line Mode 1/2 – allows the user to set the Ethernet line mode for
Network Interface 1/2.
• MAC Mode – allows the user to change the current MAC Mode.
User-editable fields in the Listening Stream Section:
• FEC Enable – allows the user to enable/disable FEC. This facility is only
available when FEC is licensed.
EN/LZT 790 0005 R1A
5-20