Need help?Do you have a question about the EScale 2.4GHz FHSS Radio System and is the answer not in the manual?
General| Brand | EScale |
|---|---|
| Model | 2.4GHz FHSS Radio System |
| Category | Remote Control |
| Language | English |
Ensure receiver, servo, and battery connectors are fully inserted to prevent flight issues.
Protect receiver from vibration and moisture to prevent erroneous operation and crashes.
Do not cut or bundle the receiver antenna to maintain signal sensitivity and range.
Adjust servo horn travel to prevent binding and avoid excessive force.
Install servos using rubber grommets to prevent direct contact with fuselage parts.
Install power switch in a location protected from engine oil, dust, and direct contact.
Operates the instructor transmitter when using the trainer function.
Two LEDs display battery voltage, power down mode, and ID setup status.
Switches to reverse the direction of servo operation; lower is normal, upper is reverse.
Details on the rear panel, including the 8 AA battery compartment.
Shows receiver channel output assignments (CH1-CH6) and LED indicator details.
Position receiver antennas at 90 degrees to each other for maximum range.
How the aileron stick movement controls the plane's roll.
How the elevator stick movement controls the plane's pitch.
How the throttle stick movement controls engine speed.
How the rudder stick movement controls the plane's yaw.
To Next Page