www.nod32.com/download/engine/mod_base.nup - the base of the
virus database and
www.nod32.com/download/engine/mod_inc.nup - the increment of the
virus database
(Both files are needed to download to create the mirror correctly)
These Update Files are downloaded (either via NOD32 Control Center
or manually) to the Mirror Directory (created by the administrator).
NOD32UPD can then update the Target Computer from this Mirror
Directory.
Application of NOD32UPD (when updating from the mirror
created with NOD32 version 1)
Introduction
This section describes the updating procedure when updating from the mirror
created with NOD32 version 1.
NOTE: The updating procedure when updating from the mirror created with
NOD32 version 2 is described in the section “Application of NOD32UPD2“
below
Procedure
NOD32UPD can be executed via a batch file. Hence, it can run without any
user intervention and is controlled by means of the command lines
parameters only. After its execution, the module returns a Return Value that
may be subject to further processing. Before using NOD32UPD, please, read
applicable information corresponding to a specific operating system included
below.
To run the NOD32UPD module it “needs to know”: a/ where the update files
are located, b/ where the NOD32 system (to be updated is) and, c/ what are
the desired command line parameters. These three items are specified in a
command line having the following syntax:
NOD32UPD mirror [directory] [parameters]
• mirror has to be replaced with the name of the directory (path)
containing the Update Files (update source). Access to this directory
must be available from the computer running NOD32UPD program,
hence, it either has to be a local disk or a network directory available
for a program executed from a command line.
• directory specifies a particular directory containing installation of
NOD32 system to be updated. This parameter is necessary in case of
6
To Next Page
Loading...