1.2 Button details
K1: Short press, record/stop recording video
Long press for 10S, reset to factory setting
S1: Turn left: ON, Turn right: OFF
1.3 LED Status
L1: BLUE ON: Stop recording in Micro-SD card
BLUE FLASH: Record in Micro-SD card
RED, ON: Charging. OFF: Charging fully.
L2: GREEN OFF: AP mode
GREEN ON: Device mode
GREEN FLASH: Try to connect to router
1.4 Brief Introduction
* Download and install the APP RTCAM
* Switch on S1 to power on the clock
Press K1 for 10s to reset the camera to factory setting is
recommended. It will take about 35s.
* Open the APP RTCAM, connect mobile phone to camera
directly in AP mode
To Next Page
Loading...