Esoteric X-01 - Disassembly and Mounting Cautions

−9−
EXPLODED VIEW-2
REF.NO. PARTSNO. DESCRIPTION REMARKS
2‑565785304100WASHER,POLY4.1X6.5X0.25T
2‑57M0187931CABLECLAMP,NYLONAB‑5N
2‑61B00145800ASCREW,JHA4X20FZC
2‑62 B00053800A SCREW,MPAR2X3FNI
2‑63 B0006360 SCREW,MPPR1.7X5.0
2‑64 5780102008 SCREW,PANM2X8
2‑65 5780013006 SCREW,BPA3X6FNI
2‑66 5780102604 SCREW,PANM2.6X4
2‑67 5780002603 SCREW,BPA2.6X3FZC
2‑68 5780103004 SCREW,PANM3X4
2‑69 5780102606 SCREW,PANM2.6X6
2‑705780103003SCREW,PANM3X3
2‑715780024008SCREW,BPA4X8FNB
2‑725780023008SCREW,BPA3X8FNB
Cautions about Disassembly and Mounting
●
After joining CLAMPER MAGNET 1 and DISC CLAMPER 2
with adhesive, ThreeBond 1359D, harden forced out surplus
adhesive with UV irradiation.
●
Avoid applying a strong pushing force to the PU BASE ASSY
when removing/installing the PUSH SW 9.
●
When fastening the SA SLED MOT ASSY a, push it against
the locating pin.
●
Fasten the STOPPER BELT PLATE @ so that there is a
clearance of 1 mm between it and PULLEY (B) PLATE ..
●
For the MOTOR HOUSING ASSY, first fully tighten down the
screws on the left end viewed from the front.
●
Avoid disassembling parts that are not "exploded" in the
diagram (such as PU BASE ASSY, MOTOR HOUSING ASSY).
Dedicated tools are required to assemble them. When those
parts are needed to replace, the MECH UNIT itself should be
replaced.
1mm
PLATE,PULLEY(B)
PLATE,STOPPER BELT
First tighten
down these
screws
HOUSING ASSY,MOTOR