For Floor Standing Installations
: Attach footplate for
floor-standing installations by laying speaker on a flat
surface. Leave poly bag in place except for bottom, this is
where the footplate is attached to the rails with 4 hex
screws. The footplate has small rubber feet to raise the
base off the floor ¼” (.63 cm). For optional Tip-Toes, see
below.
For Wall-Mount Installations
, attach
Universal VESA Standard Wall-Mount Plate
with holes pre-drilled for the 100mm or 75mm
hole pattern. The side rails are pre-drilled and
attachment screws are provided in the kit.
To Next Page
Loading...