What to do if my Esteam CLEANCO TRUCKMOUNT SLX 47 Cleaning Equipment has excessive vacuum?
If your Esteam Cleaning Equipment is showing excessive vacuum, it could be due to: * The vacuum blower relief valve needing adjustment: Re-adjust the valve, ensuring you do not exceed 13" Hg. * Improper throttle adjustment: Adjust the throttle to set the desired vacuum pressure.
What to do if my Esteam Cleaning Equipment has loss of solution pressure?
If you're experiencing a loss of solution pressure in your Esteam Cleaning Equipment, with the cleaning tool open and the solution gauge reading low, consider the following: * Low water supply: Fill the fresh water tank. * Debris clogging water lines: Clean or replace the water lines or water inlet disconnect as needed. * Air in the solution pump supply line: Check the supply line from the tank to the high-pressure pump for holes, and tighten any loose clamps or fittings. * Defective high-pressure gauge: Replace the gauge. * Dry or worn pressure regulator o-rings: Check, lubricate, or replace the o-rings as needed. * Worn, defective, or wrong-sized spray nozzle: Replace or change the nozzle. * Loose or broken pump belt: Re-tension or replace the belt.
General| Brand | Esteam |
|---|---|
| Model | CLEANCO TRUCKMOUNT SLX 47 |
| Category | Cleaning Equipment |
| Language | English |
Step-by-step guide for safely starting the truckmount engine and system.
Procedures for safely powering down the truckmount unit after use.
Routine checks and cleaning tasks to be performed on a daily basis for optimal performance.
Identifies causes and solutions for reduced vacuum performance during operation.
Addresses issues related to vacuum levels being higher than expected during operation.
Troubleshooting steps for low solution pressure at the cleaning tool.
Diagnosing issues when solution volume is low despite normal pressure readings.
Steps to troubleshoot when the pressure pump fails to activate.
Explains causes and solutions for the unit overheating during operation.
Addresses problems related to the unit not reaching or maintaining the desired temperature.
Provides guidance on identifying and resolving leaks in the heat exchanger system.
Details the warranty terms and specific components covered for 60 months.
Outlines the terms and components covered under the 24-month premium warranty.
To Next Page