ESTEBAN ELESSENS - Product Overview and Components; Diffuser Part Identification; Included Accessories; Getting Started: Diffuser Setup

7
STARTING THE DIFFUSER
Read the below-mentioned instructions carefully before starting the diffuser.
This diuser combines high-quality fragrance diusion and the elegance of ceramic, enhanced by luminous colour eects.
OVERVIEW
DIFFUSER ACCESSORIES
A: Ceramic upper part B: Electricity cable
C: Bottom part, water tank
1: Ceramic disk
2: Water level
3: Air outow
4: Button
A
B
C
4
1
2
3
maximum level 100ml
b
o
t
t
u
n
b
o
t
t
u
n
1
GB
STAGE 1
• Place the diuser on a at and stable surface away from the edge.
• Connect the electricity cable to the port at the back of the diuser without plugging it in.
• Remove the upper part A. Pour water at room temperature into the container C. Do not exceed the maximum level
of 100ml. (Warning: the diuser does not work if the water level is too low or higher than 100ml).
• Do not pour hot water into the container (risk of damage of sensitive components).
• Add 10 to 15 drops of Estéban refresher oils or essential oils, depending on the required intensity (the harshest and
most viscous essential oils should not be used as they may damage your diuser).
-  Do not pour drops of refresher oils or essential oils into the container if there is no water in it as this
risks damaging the device.
- Wipe up any drops that may accidentally have fallen outside the container.
- An excess of refresher oils or essential oils could prevent the diusion and damage the diuser.
• Ensure the upper part A is placed completely straight on the base of the diuser C.
• Do not move the diuser once you have lled it.
Bottom view