Estun ETS-101010APC-CAN - Chapter 5; Panel Operator; Basic Operation; Functions on Panel Operator

ETS Series AC Servo User's Manual
- 88 -
Chapter 5
Panel Operator
5.1 Basic Operation
5.1.1 Functions on Panel Operator
The panel operator is a built-in operator that consists of display section and keys located on the front panel of the servo
drive.
Parameter setting, status display ,and execution of utility function are enabled using the panel operator.
The names and functions of the keys on the panel operator are shown as follows:
Note: In this manual, the Panel Symbol is represented by Corresponding Key Name for easy understanding.
5.1.2 Switchthe number of Axis
Servo axisescan be switched by pressing the AXIS key when the panel operator in display mode.
Panel
Symbol
Corresponding
Key Name
Function
AXIS
AXIS key
To switch the number of axis
▲
INC key
·To display the parameter settings and setting values.
·To increase the setting value.
·To decrease the setting value.
▼
DEC key
M
MODE key
·To select a basic mode, such as the display mode, parameter setting
mode, monitor mode, or utility function mode.
·To save the setting during parameter setting and exit.
◄
ENTER key
To display the parameter settings and setting values, and release ararm.
MODE INC DEC ENTERAXIS
A
B
C