Estun ETS-101010APC-CAN - Parameter Settings Initialization

ETS Series AC Servo User's Manual
- 96 -
5.2.2 Parameter Settings Initialization
Follow the procedures below to execute the parameter settings initialization.
1.Press the MODE key to select the utility function mode.
2. Press the INC or DEC key to select the function number of parameter settings initialization.
3.Press the ENTER key to enter into parameter settings mode.
（axis A）
（axis B）
（axis C）
4.Hold the ENTER key for one second, the parameters will be initialized.
5. Release the ENTER key to ruturn to the utility function mode display Fn001.
Note：
Press the ENTER key during servo ON does not initialize the parameter settings.
Initialize the parameter settings with the servo OFF.