Estun ETS Series - Parameters Copy

ETS Series AC Servo User's Manual
- 101 -
Thus, the static inertia detection is complete.
Note：Make sure that the servomotor completes at least 6 full revolutions in the CCW direction before detection.
5.2.8 Parameters Copy
1. Press the MODE key to select the utility function mode.
2. Press the INC or DEC key to select the utility function number Fn013.
3. Press the ENTER key, the display will be shown as below.
（A-axis，Parameters are copied from A to B）
（B-axis，Parameters are copied from B to A）
……
4. Press the ENTER key, the display will be shown as below.
5. Release the ENTER key to complete position teaching function.