Summa Series Servodrive Product Manual
Document Version: V1.01
(Dec, 2019)
© 2019 ESTUN Automation Co., Ltd. All right reserved.
Symbols
The symbols that may be found in this document are defined as follows.
Indicates a hazard with a high level of risk that, if not avoided, will result in death or
serious injury.
Indicates a hazard with a medium or low level of risk which, if not avoided, could
result in minor or moderate injury.
Indicates a potentially hazardous situation that, if not avoided, could cause equipment
damage, data loss, and performance degradation, or unexpected results.
Indicates precautions or restrictions that must be observed.
Also indicates alarm displays and other precautions that will not result in machine
damage.
Provides additional information to emphasize or supplement important points of the
main text.
The names of reverse signals (ones that are taken effect when low) are written with a forward slash (/)
before the signal abbreviation. For example:
S-ON = /S-ON P-CON = /P-CON
The names of sub-parameters are written as the format of Pnxxx.x. The following takes the parameter
Pn000 as an example, whose sub-parameters Pn000.0, Pn000.1, Pn000.2 and Pn000.3 corresponding to
one bit of its value respectively.
Parameter Pn000
The Value is b0000
Press [◄] key
Pn000.0 = 0
Pn000.1 = 0
Pn000.2 = 0
Pn000.3 = 0
To Next Page
Loading...
