Estun Summa Series - Chapter 7 Application Functions; I;O Signal Connections; Input Signal Allocations

Summa Series Servodrive Product Manual
Basic Settings
Document Version: V1.01
(Dec, 2019)
© 2019 ESTUN Automation Co., Ltd. All right reserved.
4-2
4.1.2 Basic Mode Selection
The basic modes include: Status Display Mode, Parameter Setting Mode, Utility Function Mode, and
Monitor Mode. Select a basic mode with [M] key to display the operation status, set parameters and
operation references, as is shown in Figure 4-2.
Figure 4-2 Select a basic mode
[M]
[◀]
[◀]
[◀]
[M]
[M]
[M]
Status Display
Parameter Setting
Monitor
Utility Function
4.1.3 Status Display Mode
Power ON the Drive and wait for a while, the Panel Operator will initially display the Servo Status.
The information displayed by the status is divided into two parts:
 The first two digits are called Bit Data, what indicates the signal states during the operation of Drive.
 The last three digits are called Code, what indicates the operation states of Drive.
Bit Data
Code
1
2
3
4 5 6 7
The display meaning of each segment on Bit Data are shown in Table 4-1, and they have different
meanings under Speed or Torque Control Mode and Position Control Mode.