– Charging or recharging at temperatures below 10°C or higher than 40°C adversely affects lifespan
of the battery.
– Continuously recharging Clipper will reduce lifespan of battery.
1) Be certain Clipper is OFF.
2) Connect the trimmer to the adapter and plug the adapter to the mains.
3) The battery charge status is shown on the display A2 during charging (in %).
4)
It will take approximately 1.5 hours to fully charge the Clipper. Do not exceed the set time of charging!
5) After charging, unplug the adaptor from the mains rst and only then unplug the connector from
the appliance.
Notes
– During charging, the value shown on the display increases in increments of 5%. When charging
is completed, the display shows “100”.
– Every time you switch the trimmer on and off (by pressing the A1 switch), the battery charge
status will appear on the display for about 10 seconds.
Optimize the working life of the battery
– Do not charge for more than 1.5 hours.
– Do not keep cord permanently plugged in.
– Discharge / run down the battery completely twice a year by letting the motor run until it stops. Let
the battery charge fully afterwards.
Lock
1) Press and hold the A1 switch. The trimmer will stop in approximately 3 seconds.
2) A locked lock symbol will flash on the display six times.
3) To cancel the lock, press the A1 switch again and hold it for approximately 3 seconds.
Note
If the lock is active and you press the A1 switch shortly, the battery charge status will appear on
the display and the locked lock symbol will flash six times. After that, the display will switch off.
Use
The trimmer can be used without the adapter (for cutting contours) or with the selected
adapter B1–B7 according to the required cut length. Mount the attachment to the trimmer head so
that the B8 lock on both sides fits properly.
Note
When removing the attachment (B1–B7), release the B8 lock with your fingers (see Fig. 1).
Hair clipping
–
The trimmer turns on and off with a switch A1. Turn the trimmer on only after all the attachments have
been properly placed and you are ready for trimming. Turn the trimmer off immediately after use.
– We recommed oiling the blades with the oil C3 attached before first use.
– Before you start clipping, make sure that the head of the person whose hair you are cutting is at the
same level as your chest so that all parts of his/ her head are clearly visible and within easy reach.
– Only use the clipper on dry hair.
– Do not use on freshly washed hair.
– Before you begin, comb the hair in the direction of growth.
– To achieve optimal clipping results, always move the clipper slowly through the hair against the
direction of hair growth.
– In case an blades A4 gets blocked, the appliance must be turned off immediately and the cause of
the block removed.
GB
21 / 46
To Next Page
Loading...
Need help?
General
