Open the lid A5 by pressing the lock button A6. Fill the kettle with drinking water. The
minimum and maximum amount of water is marked on the water gauge A3. Close the
lid by snapping. Put the electric kettle on the stand and turn it to the I position by the A1
button. Function of the electric kettle is signaled with the control light A2. After boiling the
appliance switches off automatically. Before reaching the boiling point, you can switch off
the appliance by turning the A1 button to the 0 position. Always use fresh drinking water for
boiling.
ATTENTION
– If the kettle was removed from the stand during boiling, remains in ON position.
This means that if you put it back on the stand, it will immediately continue in
heating.
– When heating water, the lid must be closed, otherwise the steam sensor will not be
working.
– In bigger tilting of the electric kettle backwards, particularly when it is filled up
to maximum, water can flow out from the electric kettle in the bottom part of the
kettle. This does not affect safety or other functions and it does not mean any
failure of the electric kettle. In the case of tilting the electric kettle with hot water
there is a risk of scalding. Therefore do not tilt the electric kettle.
IV. MAINTENANCE
Unplug the appliance from power supply by taking the fork of the power cord
out of the socket! Clean the kettle only when it is cooled down! Do not use rough
and aggressive detergents (e.g. sharp objects, scrapers, diluting agents or other
solvents)! The casing of the electric kettle and the heating bottom is made of top-quality
stainless steel, but in common use, impurities from water get stuck on them (water scale),
particularly above the heating element. It is not rust or another material defect of the
kettle container and the appliance is not subject to a complaint for this reason.
Cleaning the kettle
Pour about 50 g citric acid to the kettle with the water scale sediment. Fill the kettle to
about one half and mix. After it dissolves, fill the kettle to 3/4 of the maximum amount of
water. Place the electric kettle on the stand and turn it on. Before boiling, turn off the kettle,
let the solution take effect for about 10 minutes and then pour it out. Clean the kettle
thoroughly with clean water. Repeat the whole procedure if the kettle is too soiled. Clean
the electric kettle regularly!
Cleaning the sieve
Take the sieve from the kettle. Clean it from possible sediments in running water using
a fine brush. Then put the sieve back in the opposite way.
V. ENVIRONMENT
Printed signs of materials used for manufacture, packing, components and accessories,
as well as their recycling, are on all the pieces if their dimensions enable it. The symbols
on the product or in the accompanying documentation mean that the used electric or
electronic products must not be disposed together with municipal wastes. Please, hand
them over to the collection points designed for their correct disposal, where they will be
accepted free of charge.
13
GB
To Next Page
Loading...
