Etbu EEB-181 - Page 16

To Next Page

To Previous Page

4. Assemble the Rear Stand

5. Assemble the Pad Hanger

Insert pad hangers (two) into the holes on the upper

part of the stand. Turn the hangers into the holes

tightly till they cannot turn any more.

6. The completely assembled product

Tighten the three screws with a screwdriver.

Put the rear stand into the slot of the bottom of

the foot pad assembly by tilting it and t into the

front stand tightly.

After tightening the screws, engage the covers in the

three screw tightening slots on the rear stand.

Engage the thick cover on the top of the stand followed by

the remaining two covers in the middle and at the bottom.

Main Body

Rear Stand

Screw

Stand Upper Lid

Stand Middle Lid

Pad Hanger

4. Product Installation