Etherma LAVA BATH 2.0 - Page 9

Dimensional drawing: minimum mounting clear-
ances
35 mm
35 mm
35 mm
35 mm
INSTALLATION AND MINIMUM DISTANCES:
LAVA
®
BATH infrared heating devices have to be mounted so
that
ammable objects cannot catch re. Be absolutely sure
to comply with minimum clearances, in particular to highly
combustible objects such as curtains, upholstered furniture,
etc. Please also make sure that the infrared heater can radiate
freely into the room.
ATTENTION: Strain of any kind on the surface,
whether from persons or objects leaning against it
or from other forces, must be avoided!
CLEARANCES
The LAVA
®
BATH infrared heating must be mounted exclu-
sively using the xing components included in the scope of
delivery.
Screws and dowels (not included in the scope of delivery) must
correspond to the construction material of the wall (masonry,
concrete, plasterboard, etc.). The surface of the wall must be
even.
SCOPE OF DELIVERY | PACKAGING
STANDARD SCOPE OF DELIVERY FOR WALL MOUNTING:
› LAVA
®
BATH 2.0 INFRARED HEATING
- 2 x mounting brackets
- 4 x hexagon bolts M8 x 16
- 1 x LAVA
®
HALTI towel holder
ATTENTION: The wall must be even. Otherwise
damages on the surface of the LAVA
®
BATH infra-
red heating device may occur.
STANDARD SCOPE OF DELIVERY FOR WALL MOUNTING:
› LAVA
®
BATH 2.0 PURE INFRARED HEATING
- 2 x mounting brackets
- 4 x hexagon bolts M8 x 16
- 1 x LAVA
®
HALTI towel holder white or nano-anthracite
9