INTRODUCTION
GENERAL
With your choice of ETHERMA you have decided on an ingenious hea-
ting solution. We thank you for your condence. In us you have a com-
petent partner with more than 35 years of experience. ETHERMA relies
on constant innovation , highest product quality and modern design.
We support you with comprehensive personalized services and nd the
right product solution for you.
The following instructions will help you, to use your ETHERMA quality
product as effective as possible. They contain important information
about safety, installation, use and maintenance of the devices. Please
read the information in this instruction carefully and keep them for
feedback at a later time on.
LAVA
®
design infrared heaters from ETHERMA are direct
heaters which are versatile in use. Further on they attract by
elegant design, simple installation and easy operation. High
reliability and maximum performance with minimal radiation
convection convince our costumers.
This guide provides important information on safety, installa-
tion, use and maintenance of the equipment. Please read the
information carefully.
The manufacturer is not liable if the following instructions are
not followed. The devices may not be misused.
The packaging of your LAVA
®
design infrared heater consists of
recyclable materials.
ATTENTION: Operation of the heater causes high tempe-
rature on the glass surfaces. Prolonged contact may cause
burns. Please make sure, that children or inrm persons don’t
get in touch with it.
This heater is not intended for use by persons (including child-
ren) with reduced physical, sensory or mental capabilities or
lack of experience and knowledge of using the radiator. Unless
they are supervised by a person responsible for safety or recei-
ved instructions about how the device should be used. Children
should be supervised to ensure that they do not play with the
device.
The heater must not be placed or mounted directly below a wall
socket.
WARNING: Covering the surface causes
overheating danger! Already a local covering
of the pane, for example with a towel can
lead to overheating and cause damage of the
heating element.
WARNING: Do not use the heater if the front is broken.
Overheating and overload protection
Each heater has an overheating protection. The device automa-
tically starts again after a cooling down to under 45 °C.
These instructions must
› be passed to the operator after the installation. In addition,
the operator is trained in the operation of the radiation heater.
› be carefully kept and handed over at change of ownership to
the new owner.
2
INSTALLATION AND USAGE INSTRUCTION | LAVA
®
DESIGN INFRARED HEATER
CAUTION: Do not switch on the LAVA
®
CERAMIC
until the ceramic plate has adapted to the ambient
temperature.
To Next Page
Loading...