EN 11
INSTALLATION
Mounting
Drilling the Support surface and Fitting the Hood
• The hood support surface must be 229 mm above the bottom
surface of the wall units.
• Saw an opening in the surface for the cooker hood outlet.
• Fit the hood to the surface using the screws.
• Connect the exhaust-air pipe to the motor flange.
Closing element
• The space between the edge of the hood and the rear wall can
be closed by applying the element ‘L’ provided, using the screws
supplied for this purpose.
P
L
P
598 - 898
501 - 801
14
48.5
281
42.9
64.5
130.7
42.9
To Next Page
