Table continued from last page
ActionPossible causesProblem
Check the door lock. If it does
not click into place and lock,
open the door.
The door lock has not clicked
into place and locked.
Press and hold the button for
the Auto open option until the
button starts flashing. Wait until
it stops flashing (60 seconds).
Close the door. Check that the
door lock clicks into place and
locks.
Check.A fuse/circuit breaker has been
tripped.
Check.The plug is not plugged into the
wall socket.
Check.The water tap is turned off.
Check.Overflow/leaks.
Turn off the water tap. Pull out
the plug and call the service
department.
A whirring sound (the drainage
pump) is heard from the dish-
washer and does not stop when
the main power switch is turned
off.
Press and hold the main power
switch until the display turns off
if you want to cancel the
Delayed start option. Restart the
dishwasher.
Check that the Delayed start
option has not been selected.
Remove the arms and clean
them.
The spray arms do not rotate.The dishes are not clean.
Check that the dishes are not
blocking the spray arms.
Clean the spray arms. See the
chapter Care and cleaning.
Spray arm holes or bearings
blocked.
Select a program with a high
temperature to dissolve grease
on very dirty dishes, such as In-
tensive wash.
Unsuitable dishwashing pro-
gram.
Dose according to water hard-
ness. Far too much or far too
little detergent results in poorer
dishwashing results.
Incorrect detergent dosage.
Avoid large packages.Old detergent. Detergent is a
perishable product.
Do not cover porcelain with
large bowls or the like. Avoid
placing very tall glasses in the
corners of the baskets.
Dishes loaded incorrectly.
28
To Next Page
