01
EN EN
02
Getting Started
1. Shut the power off at the breaker in your house. Switch on/off the
lights to make sure the electricity in your house is properly shut off.
2. Determine the area you want to be lit and camera coverage is required.
Install your Floodlight Camera on the front wall or on a side wall of your
house. To get optimal detection and light coverage for the floodlight and
camera, install it on a side wall if possible. *
* The motion sensor is more sensitive to movements across the camera field of view than
movements towards or away from the sensor. We highly recommend you install the
floodlight camera on the side wall.
Safety Instructions
1. Shut off power at the fuse or circuit breaker before installing.
2. Do not install the device near flammable surfaces.
3. Must have a licensed electrician install the Floodlight Camera.
4. Do not use the device in environments where the temperature is too
high or too low, avoid exposing the device to direct sunshine or very wet
environments.
5. The suitable temperature for the product and accessories is -20°C to
50°C.
What's in the Box
Floodlight Camera 2K
(T8424)
Junction Box
Central Screw Cap Plate Screws
Installation Hook
Central Screw
To Next Page
Loading...
