HYDRABEAUTY
11
1. Choose the tip for use and connect to the handpiece correctly.
When replacing the size of the tip, pull the tip out and connect it to the handpiece correctly with the tip
you want to replace.
4.2 Handpiece installation
4. Product installation
2. When the treatment is done, in the case of cleaning or storing, should remove the tip and apply the cap on
the handpiece.
-Remove the tip- -Applying cap- -Correctly applied-
-Connector part- -Tip installation- -Correctly installed-
NOTE
Clean the hand piece cables after the solution 2 procedure using the " C " cleaning mode before
do the solution 3 procedure.
After all procedures (after all 3 solutions ), clean the handpiece again with cleansing mode and
store it.
4.2.3 Aqua tip connection
To Next Page