Brief description eurogard ServiceRouter V2 2/23
eurogard GmbH Kaiserstraße 100 D-52134 Herzogenrath T.: +49/2407/9516-0 F: +49/2407/9516-23 www.eurogard.de
Hardware ServiceRouter V2
Connection and control elements
The ServiceRouter is designed for installation in a switch cabinet using the mounting rail on
the back cover.
Supply voltage is 18-30VDC/6-18W. The two input terminals for the ± Potential are isolated
by means of diodes. This allows for a redundant voltage supply to the Router, as long as the
ground potential of the sources is at the same level. The +24V LED signalizes adequate
supply to the device.
The Reset button restores the
factory settings of the device. If
required, please press and hold for
at least 3 seconds.
The Setup button copies the last
restore point to the configuration
level. Before use, a restore point has
to be saved in the Router.
The Status LED signalizes the VPN
status.
OFF: VPN terminated
FLASHING: VPN initializing
ON: VPN connection established
The Error LED signalizes the status
of the processor.
ON: Error
FLASHING: Router initializing
OFF: Router in operation
UMTS P Modem module supplied
with voltage
UMTS L Modem module logged into
mobile network
ServiceRouter V2: Technical specifications
- Platform: AMD-Geode 500MHz 256 MB RAM
- 2 GB Flash-Disk, expandable on demand
- Battery backed real-time clock, hardware-Watchdog
- 1 x WAN, 2 x LAN switched, each Ethernet 10/100
- 2 x USB for USB-disk, WEB-Cam and customer add-ons
- miniPCI-slot internal for 54 Mbit WLAN-Option
- Version with UMTS/HSDPA modem available
- Version with 4 digital inputs, 2 outputs available
- Voltage supply 12-30 VDC, 8W (basic version) 18W full version
- Ambient temperature 5-50°C, non-condensing
- DIN-rail mounting
- Dimensions: H:156 W:59 D:160 mm
To Next Page
Loading...