EUROM Coolsmart 90 - Advanced Appliance Features; Auto-Restart and Power Management

76
- The Off light will come on.
- Press on < > to set the desired switch-off time. Every time you press these
buttons, the time jumps forward by 30 minutes until 10 hours and henceforth by
1 hour until maximum 24 hours.
- Press once more on the Timer button.
- The On light will come on.
- Press on < > to set the desired switch-off time. Every time you press these
buttons, the time jumps forward by 30 minutes until 10 hours and henceforth by
1 hour until maximum 24 hours.
- Five (5) seconds after you have set the Timer, both On and Off lights will come
on.
Switching off
- Turning the air conditioner On or Off or setting the timer setting to 0.0 will cancel
the Timer.
Attention! If the appliance switches off due to an error message, then the set times
are also cancelled.
Sleep (ECO)
- Press this button to switch on the low-energy sleep function.
- After 30 minutes, the appliance will raise the set temperature by 1°C and after
another 30 minutes, again by 1°C.
- The air conditioner will stay at this temperature for 7 hours and later it will switch
automatically back to the set temperature. The sleep function is then ended.
- This function does not work with the Fan or Dry functions.
Swing
- With the Swing button, you automatically move the horizontal outlet slats up and
down when the air conditioner is activated. If you press again on the Swing
button, the slats will stop swinging in whichever position. Never try to force the
slats manually to a particular position.
Furthermore:
- The air conditioner is produced with Auto-restart, which restarts the air
conditioner automatically in the set functions if there was a power cut.
- The appliance is manufactured with Power Management: if the ambient
temperature is lower than the set temperature for approximately 30 minutes,
then the appliance automatically switches over to this position in which the
compressor and fan motor are switched off. When the temperature rises, they
switch on again.
- After the appliance has stopped operating, it takes three minutes before you can
switch it on again. This is to protect the appliance. After 3 minutes, it
automatically starts to operate again.