46
Warnings – use
1. Do not use additions/accessories on the device that have not been
supplied or approved by the manufacturer.
2. Only use the device for its intended purpose and in the manner set
out in this instruction leaflet.
3. Some parts of this device will get very hot and could cause
burns. You must pay particular attention to children,
vulnerable persons and pets that are present near the
device. Never leave them alone with a working device.
4. Never cover or block the device; it will overheat and this could lead
to a fire risk. Never hang or place objects such as clothing, towels,
blankets, cushions, paper, etc. on the device. The minimum
distance of 1 metre between the device and flammable materials
must always be applied. Never use the device to dry clothing or
place anything on it. Do not let anything lean against the device!
5. The device is exclusively intended for normal, household usage.
Only use for providing heat in your home.
6. The connection voltage and frequency, as given on the device, must
correspond to that of the socket to be used. The electrical socket to
be used must be an earthed connection. The electrical installation
must be protected via a 30 mA earth leakage circuit breaker. The
electrical socket that you are using must be to hand at all times in
order to be able to remove the plug from the socket in the event of
an emergency.
7. To avoid overloading and/or fuses being blown, do not use any
other equipment on the same socket or electrical group as the one
used for the device.
8. Unroll the electric cable for the device fully before inserting the plug
into the socket and ensure that the electrical cable does not come
into contact with the fireplace or get hot. Do not run the electrical
cable under carpet, cover with mats, runners or similar and do not
place in areas that are walked on frequently. Ensure that it cannot
be stepped on and that no furniture is placed on top of it. Do not
bend the electrical cable around sharp corners and do not roll up
too tightly after use! Prevent the electrical cable coming into
contact with oil, solvents and sharp objects. Check the cable and
plug regularly for damage. Do not bend or pinch the electrical cable
and do not wind it around the device; this could damage the
insulation!
To Next Page
Loading...
Need help?
General