CHARACTERS
1
、
Optimized design,elaborately making,the fan is luxury,safe and easy to use.
2
、
Adopt nice pressure casting technology,light weight and large air delivery.
3
、
Excellent winding design and with ball bearing,low noise and durable.
4
、
Build thermal fuse in the motor and ensure overload protective.
5
、
With three speeds,wind angel can be adjusted up and down.
6
、
It is suitable to be used in living room,marketplace,hotel,warehouse and so on.
OPERATING INSTRUCTIONS
1.Refer to assembly scheme to assemble the fan, before assemble, please check parts
carefully if any damage during shipment.
2.Move blade before operation, check if flexible and any rubbing with other parts,(Don't
deform the blade).
3.The voltage and frequency should same as the motor label fixed, don't use it in corrosive
and other wet environment.
4.Don't use the fan beyond the height of elevation 1000 meters. and don't use in place with
temperature over 40ºC.
5.When power supply come from socket, the play must accord with IEC335-1.When the
power code is connected with charging line directly, all-polarity switch that the contact gap
is 3mm at least must be in the charging line.
6.By turning switch (8)of floor fan and stand fan can get three speeds,select one of three
speeds, on switch label 0,1,2,3indicates OFF,SLOW SPEED,MEDIUM SPEED,HIGH
SPEED.wall Fan can pull the timing-switch(24) or turn the switch (22) get three
speeds.lable 0 indicates OFF, for HIGH SPEED, for MEDIUM SPEED,
for SLOW SPEED.
7.Oscillation control: For Stand Fan and Floor Fan,press oscillating-button (7) to make the
fan oscillate or stop oscillating.For Wall Fan,pull the oscillating-cord to oscillate or stop
oscillating,and it will exchange once pulling.
8.Pitching control turn off the fan and cut the power supply, hold the top and end of the net
can adjust the angle up and down, This for floor and stand fan. Fitching control for wall
fan,turn off the fan and cut the power supply, hold the mount tube, unscrew(28), will
adjustable,then fixed the screw.
9.height adjustment of pedestal fan: Turn off the power, hold the upper part of the fan (10)
firmly after the blades stop running, and then loosen the plastic locking cover (13) from
clockwise direction, adjust the stand pole of the fan to ideal height, and tighten the plastic
locking cover from the anti-clockwise direction. The height of the floor fan and wall fan is
not adjustable.
10.The wall fan should be installed 2.3 meters or more above the ground
11.Base installation: Loose the L bolt on the bottom of the stand pole and remove the
fastening flange, insert the stand pole into the center hole of the base, put back the fastening
flange and tighten the L bolts.
To Next Page
Loading...
Need help?
General
