What to do if the pressure piece falls out of my Eurotronic Controller?
If the pressure piece of your Eurotronic Controller falls out (which can also cause an E1-error), it might be because it wasn't properly affixed to the valve, causing it to detach due to an endless thread. To fix this, remove the batteries, reinsert the pressure piece, and then reinsert the batteries. This will rotate the endless thread and secure the pressure piece again.
Why is my Eurotronic Spirit Z-Wave Plus Controller heating element not warming up?
If your Eurotronic Controller's heating element isn't warming up, the boiler water temperature might not be optimal, or the valve could be calcified from being paused during the summer or heating season. Try adjusting the boiler water temperature. If that doesn't work, remove the Comet Blue and manually move the valve back and forth, either by hand or with a tool.
What to do if Eurotronic Spirit Z-Wave Plus Controller heating element does not cool down?
If your Eurotronic Controller's heating element isn't cooling down, the valve might not be closing completely, possibly due to a shift in the valve seat's closing point. Try unmounting the Spirit Z-Wave Plus and manually moving the valve stem several times. If this doesn't resolve the issue, it's possible that your valve is calcified or the seat is no longer functioning correctly.
What does 'Err' mean on my Eurotronic Spirit Z-Wave Plus Controller?
If your Eurotronic Controller displays 'Err', it could be due to a failed inclusion. This may be caused by the Z-Wave Controller being out of range. Also, check if the valve is jammed or if the Spirit Z-Wave Plus is correctly mounted.
How to fix the battery icon on Eurotronic Spirit Z-Wave Plus Controller?
If the battery icon is showing on your Eurotronic Controller, it means the batteries don't have enough power. Replace them to resolve this issue.
General| Frequency | 868.42 MHz |
|---|---|
| Interface | Z-Wave |
| Control type | Touch |
| Product color | White |
| Smart thermostat | Yes |
| Units of measurement | °C |
| Temperature increment | 0.1 °C |
| Connecting thread type | M30 x 1.5 mm |
| International Protection (IP) code | IP20 |
| Temperature control range | 8 - 28 °C |
| Battery type | AA |
| Power source | Battery |
| Battery voltage | 1.5 V |
| Number of batteries supported | 2 |
| Quantity | 1 |
| Handheld remote control | No |
Weight and Dimensions| Depth | 89 mm |
|---|---|
| Width | 56 mm |
| Height | 68 mm |
| Weight | 176 g |
| Package depth | 66 mm |
| Package width | 106 mm |
| Package height | 132 mm |
Step-by-step guide for adding the Spirit Z-Wave Plus to a Z-Wave network.
Instructions for physically attaching the device to a radiator, with or without an adapter.
Details the process of mechanically installing the device onto the radiator valve.
Procedure to reset the device to its original factory settings.
How to change the desired room temperature using the device's controls.
Details parameters for configuring device settings like LCD, backlight, and reports.
To Next Page
