EV Rider S19AF - Charging Procedures and Care; Emergency Charging; Battery Charging and Care

EMERGENCY CHARGING PROCEDURE
BATTERY CHARGING AND CARE
The scooter comes with an emergency charging cab le .
If the scooter is folded up and the battery i s
completely flat, then the standard charging s ocke t
ca n be difficult to acce ss . In t h i s in s ta nce , the
emergency charging cable can be installed to allow
the battery to be charged while the scooter is fol d e d .
The emergency charging cable is shown below:
To install the charging cable, plug t h i s in to connector
cable at the front of the underside of the s coote r
(as shown b elow) .
Install the cable, then proceed to charge the battery
as described in the next s e cti on .
Step 1. Insert the charger in to the power outlet and
s witch the power on . Ensure the charger is not
connected t o the scooter, and one of the charger
LEDs is lit g re en .
Step 2. In s e r t the round plug on the charger in to the
charging port of the scooter (arrow b elow) . The LED
should change from green to red. The LED will
change back from red to green when charging is
comple ted .
The scooter should be left on charge until the battery
is fully r ech a rge d . A full recharge t a ke s around 5
hours . The status of the charge is shown by the LED
lights on the charger, and is described b e low :
Statu s
Power LED
Status LED
Standby or Charging
Complete
RED
GREEN
Charging in p rog re ss
RED
RED
Over cu rr en t/ v ol tage/
Tem p e ratu re , or other
fault s ta t u s
RED
Fla s h i n g
RED and
GREEN
Ensure that the charger is removed from
the power outlet and the scooter after
charging. Failure to do t h i s may flatten
the ba tte ry . Do not remove the battery
pack while the scooter is switched on .